Canopy Fittings, Canopy Pieces, Tent Fittings
Friday, March 30th, 2012“
Build your Carport, Party Tent or other project with our Canopy Parts, Ball Bungees, Tarps and with pipe that you buy locally and build it exactly how you want it and not have to settle for what?s available, which you probably would if you bought one of those Boxed Canopy Kits with pipe, plus you avoid the great cost of shipping that heavy pipe. We Have All Types of Tent Fittings Flat Roof Fittings ? For Building Flat Roof Canopies, but also used in many other creative ways like the Firewood Storage Rack.
Low Peak Roof Fittings ? 102 Degree are most popular canopy parts works great especially for the bigger tents. Most Flea Market Booths use these fittings. High Peak Roof Fittings ? 120 Degree angle this is by far the most commonly used tent fitting in the Car Canopy kits whether you buy it locally or on the internet. Works great for when you need the extra clearance for your Car, Boat or RV, also great for High rainfall areas.
There are only two types of fittings for this: 1.
High Peak Corner and Peak End they are the same canopy part. 2. High Peak Side and Peak Middle they are the same canopy part.
Canopy Foot Pads ? There are 2 types of foot pads, Cement Foot pads that are roughly 12 inches long that you set in concrete, and the 3 hole Canopy Foot Pads that you can bolt to the concrete with anchors or put the smaller tent stakes through the holes to anchor it into the dirt this will not work on sand or loose soil or gravel. The flat bottom of the 3 hole Foot Pad will also add stability to your legs when they are used on dirt or gravel. Sliding Fittings Canopy Parts? Are used to add bracing to your walls and for making a reinforced canopy roof, or adding extra bracing in your roof, these fittings slide up and down the pipe you lock them in place with the eyebolt. You can also make pipe or lumber storage racks.
“
From: (check this page) http://www.ysbw.com/Canopy-Fittings-Canopy-Parts-Tent-Fittings-s/37.htm